tainless steel SAF and SDAF , ina SNV100-LPillow Blocks

corrosion proof flang bearing

Round Stainless steel Four-Bolt Heavy Duty Flange Bearing Unit

Oval stinless steel flange beating unit

Stainless steel ball bearings

 Saves You Money

How an Extreme Bearing saves you big money

Everyone loves a bargain. So when a customer buys a new bearing unit. They often pay extreme attention to the purchase price. Especially if they work in
procurement. This can be misleading. When the real cost is determined by running and maintaining the equipment. Where the bearing unit will be installed. How much a bearing will cost your company in the long run depends on this.

Here’s one real-life example. Of how much an unplanned bearing failure can cost. It comes from a case story published in 2019 by Tetra Pak. About a dairy customer in Spain. The separator is a critical part of the line. In any dairy processing plant.

A cast irion plummer block bearing that need be replaced

If the separator is not performing as it should, it can cause a stoppage. Due to the high utilization of separators that can be around 6,000 hours on a yearly basis. It was important for the Spanish dairy to avoid unplanned stoppages. If the bearing fails unexpectedly, the Tetra Pak separator needs to be dismantled. And reassembled which requires 48 hours of downtime. In this case, it was estimated that by avoiding a single unexpected bearing failure. The customer could save €45,000 in spare parts,
labour and lost production. That’s a lot of Euros! (Incidentally, Extreme Bearings are not used in Tetra Pak separators.)

Critical factor

The point is that uptime and the working lifetime of the bearing is a critical factor to take into consideration, not just the purchase price. Every customer wants to avoid downtime and keep their plant running as planned. In fact, the
initial cost of the long-lasting Extreme Bearing becomes almost irrelevant.

When you consider how much money it can save you by avoiding lost production and maintenance costs. Therefore see an Extreme Bearing as a good investment; perhaps the best bearing investment you will ever make.

Cost-effective solutions:

  • Increase equipment uptime. Reduce maintenance costs.
  • One-time investment saving money by reusing housings while changing only the worn-out bearing inserts.